ICE-MAKER CONTROLLER / ESP32 APPLICATION
Chang Hong Ice Maker Esphome
长虹CH-Z6Y3制冰机接入HomeAssistant ESPHome固件，通过ESP32-C3实现状态识别、远程开关、大小冰切换与UV控制
About this project
About this project
A Changhong CH-Z6Y3 ice maker gains a Home Assistant presence by tapping its five-wire P1–P5 panel with an ESP32-C3 Super Mini. The board reads the panel lines as high-impedance ADC inputs at about 1 kHz and recognises standby, large ice and small ice from relative signatures such as `0HHHH` and `MHMHH`, then presses the original keys by pulling a GPIO low for roughly 100 or 80 ms. Power, large/small ice and an UV toggle show up as HA entities over ESPHome's native API. No common ground is used and the C3 runs from its own USB supply; the direct GPIO hookup is called electrically risky, with current limiting or isolation advised for long-term use. Only CH-Z6Y3 is supported.
From the README
From the README
- Power
- ESP32-C3 单独用 USB 供电，不从面板取电。
Hardware
Boards: ESP32
Supported hardware: ESP32. Confirm the exact board revision and pin map in the upstream repository.
What the source supports
Upstream evidence: Reviewed from public README media at commit 8e0412439339 under BSD-3-Clause. Firmware was not executed.
Media credit & rights
Upstream project media · rights remain with its owner · Credit: Ljzd-PRO
Screenshots decoded from the upstream README at a pinned commit. Repository code and firmware were not executed; the license texts are included in the preview package.
View original source ↗ Copyright & removal · Reviewed
More projects on these boards
AIDlink Acid Box Arduino Tesla Seat Async Esp Fs Webserver Attic Fan Bb Talkie
See what an ESP32 project looks like, and whether it runs on your board.
FILTERS
Browse by form factor. Check the exact board, chip and peripherals before installing.
Try a project
Newest listings
Give your project a little spotlight.
Repository links do not imply author endorsement or verified hardware compatibility. Check the upstream safety guidance before powering or flashing a build.